Console Team

1. Normalize the console and exercise channels to ensure all are functioning properly, using Total Recall if needed.
2. Check Correct Central Routing Panel Sections
   1. Assign Fader to Mix A using SSL Matrix
   2. Monitor Mix A using monitor section
   3. Adjust Monitor Level Dial to reasonable level (3-5)
3. Check Channel Strip Routing
   1. Engage the tracking circuit (usually MIC)
   2. Engage the playback circuit (usually LINE)
      1. If using Split-Channel mode, both circuits will be engaged on the same channel strip.
   3. Engage Mix A on playback channel strips
   4. Have the metering reflect either Pre-DAW or Post-DAW
4. When applicable, engage cue A and set to 75 percent, coordinating with Communications Team to ensure levels in Hearback are correct.
5. Once the mic lines are patched into the channel inputs for a particular channel, apply phantom power to that channel (check with setup team)
6. Set tracking levels by adjusting preamp levels and pads.
   1. Make sure to clear any ProTools overages and ensure that tracking levels never exceed -6 dBFS.
7. Group elements together using the Center Faders
8. Use Fader Links to link stereo elements together
9. Mixing
   1. Perform console EQing and compression according to guidelines on the EQWise plugin or a resource like this EQ cheat sheet↗.
10. When applicable, set FX send levels and coordinate with the Patchbay Team to ensure that signals are strong and healthy.

Closing Job

1. Produce Rough Board Mix.
2. Tear down and restore the default DualityRemote template, normalizing the console using total recall